When the estimate runs
You see the battery estimate for your own trail camera that is In field and has GPS filled in. At home, when stolen, for someone else's trail camera or without GPS, the detail doesn't calculate it.
What we measure and what we calculate
For every trail camera with GPS, we measure the weather right at its spot: real solar radiation, cloud cover and temperature from the Open-Meteo weather service. For every past day (the last 90 days) and hour by hour today. That tells us how much sun the panel really got and how cold it was.
An ordinary trail camera doesn't send us its battery level. So we calculate the battery percentage: from the measured weather, the battery level you enter and the data about the trail camera model.
A trail camera with built-in GPS and a modem reports in when someone shakes it or when GPS finds it more than 50 m from where it was mounted. With that report it also sends the measured battery voltage (for example 3.90 V). You'll see it with the report on the Theft Alerts page and in the report email. It doesn't feed into the calculated percentage yet.
Where the calculation starts
It starts from the battery level (%) you enter for the trail camera (100 % if you leave it empty), counted from the deploy date.
When you later change the battery level in the trail camera's edit form (for example after swapping batteries), the calculation starts again from that day. The 🔍 Check button doesn't change the calculation — it only records the date of the check. 📊 End Monitoring clears the battery level and you enter it again at the next deployment.
The battery capacity comes from the model's profile. A custom trail camera without a profile is calculated with 4,400 mAh.
Daily consumption
For each day the calculation adds up:
- standby — the model's draw while it just waits for motion (from the profile),
- recordings — how many day and night recordings per day you entered (1 and 2 by default),
- 4G — the daily draw of models with a SIM card (from the profile).
For video, the draw while recording is 300 mA during the day. At night 450 mA is added for the infrared illumination, 750 mA in total. You set the video length (110 seconds by default). Resolution changes only the electronics part of the draw, not the illumination: 480p ×0.85, 720p ×0.9, 1080p ×1, 1296p ×1.08, 2K ×1.15, 4K ×1.3.
For photos, the draw per photo comes from the model's profile. A night photo counts 1.8 times, because of the illumination.
Cold
In frost a battery gives less usable energy. The calculation handles this by dividing the daily consumption on a cold day by a factor based on the temperature:
- lithium AA batteries cope with frost well: below 5 °C ×0.99, below 0 °C ×0.97, below −5 °C ×0.95, below −10 °C ×0.93, below −20 °C ×0.90,
- Li-ion packs and lead-acid batteries lose more: below 5 °C ×0.9, below 0 °C ×0.8, below −5 °C ×0.65, below −10 °C ×0.55, below −20 °C ×0.4.
The temperature is the real daily temperature at the trail camera from Open-Meteo (for the last 90 days). For older days, or when the value is missing, the month's average temperature is used.
Solar panel
For solar trail cameras, what the panel produced is added to each day. If the panel is marked as covered, nothing is added.
- Sunlight. For each day, the real amount of solar radiation at the trail camera's GPS position comes from Open-Meteo (last 90 days). Cloud cover and fog are already included in it. For older days, a monthly average for Central Europe is used.
- Panel direction and tilt. The panel is assumed to face the same way as the lens, i.e. the azimuth you entered. The panel tilt is 15° (some models have a measured value in their profile). Without an azimuth, the panel is treated as flat.
- Shade. The 🌲 Terrain choice sets how much light reaches the panel when the trees are in leaf: open 90 %, forest edge with the panel in sun 90 %, light woods 40 %, closed-canopy forest 10 %, dense forest 4 %, deep shade 2 %. In winter without leaves the forest lets more through (light woods 65 %, closed-canopy 55 %, dense 22 %, deep shade 5 %), and in spring and autumn it changes gradually. Direct sunlight that gets through a gap in the canopy counts in full. The weak scattered light under the canopy is reduced further, because a small panel produces almost nothing from it.
- Output. Panel power (W) × sun hours × 0.8 (panel losses) × 0.85 (charge controller).
- Charging in frost. A Li-ion pack doesn't charge in frost: at a daily average of +2 °C or more it charges fully, at −6 °C or less not at all, partly in between. A lead-acid battery charges in frost too, just more slowly, down to 60 % at −15 °C. For a trail camera on AA batteries with a panel, nothing is reduced.
The battery can't go above 100 %. Whatever the panel produces beyond that is lost.
Today
Days from the start of the calculation up to yesterday are counted in full. Today is counted only up to the current hour: consumption in proportion to the time of day, and panel output only from the hours that have already passed. That's why the percentage changes during the day.
Weather is downloaded as many times a day as you set in Settings. At night, when the sun is below the horizon, it isn't downloaded and the last daytime weather is used.
Backup batteries
Some solar trail cameras have a compartment for AA batteries besides the built-in pack. If you choose a battery model in AA, AAA, C or D format and the number of cells for the trail camera, the calculation treats them as a backup:
- they're full at the start of the calculation,
- they're only used once the main battery is empty,
- the panel doesn't charge them,
- in frost they use the gentler curve of lithium AA batteries.
What the calculation doesn't know
- It doesn't know how many times the trail camera actually triggered. It uses the number of recordings you entered.
- It doesn't know how old and worn your batteries are.
So the best thing is to check the battery level on the trail camera's display at every visit and enter it in the edit form. The calculation then starts from the real value.
What you'll see of all this in the trail camera detail is described in The trail camera detail. Practical advice on when a solar panel pays off is in Trail camera battery life and solar.